Operation Hearth Re-Tile - Demo Time

After I received all the inspiration I needed from The Tile Shop, I was more than determined to demo the heck out of our old, outdated hearth.

To get things started, I used a hammer and flat head screw driver to pry up the front piece of wood trim that surrounded the hearth.  I slowly, and carefully, worked my way across the piece of wood...focusing my efforts where each nail was shot into the wood.  By prying things up in those areas, I had less of a risk of splitting or cracking the wood.

Once that piece was up, I put it to the side {keeping the nails in place so I could easily hammer the trim back down in the future}.  I could now see that the tiles used were super thin, and the concrete bed they were laid in was almost two inches thick, and the edges of it were crumbling.

To remove the super thick concrete bed, I busted out the crowbar.  I lined the edge the bar up with the bottom of the concrete.  After hammering a few times, I pulled back on the crowbar, and the concrete buckled.  Luckily, the majority of the hearth came out in a few huge chunks.

Once that layer was removed, I was left with a very jagged and uneven bed of concrete. 

It wasn’t exactly a flat or smooth sub-floor to build off of.  At this point, I started questioning things.  Why the heck did I think I could do this project?  How the heck would I smooth things out?  How am I going to build the surface up enough so it’ll be flush with the wood trim again?  I’m. In. Over. My. Head.  Soooo at that point, I went to bed. ;)

After I slept on things, I woke up with renewed confidence I could get it done.  To solve my issue, some people recommended using a self-leveling compound, but it just didn’t seem right to me.  The gap to fill was too big, and we were on the second floor.  If the compound seeped through any cracks {and believe me, there were a ton}, it’d go right through the floor and onto our furnace and hot water heater.  No bueno.  Instead, I turned to Henry’s Floor Patch and Leveler.  This stuff had the right consistency for my needs and was made to bond to concrete.

Following the instructions, I cleaned the concrete so it was free of any dust or debris.  {I also put the front piece of wood trim back on so all sides were the same height.}

 

Then I worked in sections...dampening the concrete with a sponge and then applying the floor leveler with a trowel.  I went through a few buckets of this stuff, and applied it in several thin layers {over several days}...gradually building up certain areas without piling the product on too thick.  After each application, I left things to dry overnight, and by morning it was always rock solid.

To figure out how high I needed to build up the base of my hearth, I took into account the thickness of my marble tile, plus the thickness of thinset to be used when installing marble mosaic tile.  Of course, I knew I wouldn’t be able to get the hearth perfectly level, but I could account for any inconsistencies by using more or less thinset to keep the tiles flush with each other during installation.

Thankfully, after a couple applications of Henry’s and a ton of patience, the hearth was finally ready for some new tile!

I couldn't believe how long it took me to get to the tiling point of this project, but I was so happy to be there!  I just wanted to get on to the pretty stuff. ;)

Anyone else question their ability halfway through a project?!?!  Did you keep going, or hire a professional?

Operation Hearth Re-Tile - The Tile Shop Inspiration

For those of you who follow me on Instagram, you may remember that over the winter I developed a major itch to demo our old fireplace hearth and replace it with something dreamy {and more our taste} from The Tile Shop.

When we purchased our home, we were sooo excited to have a fireplace, but the finishes of it definitely weren’t our style.

We knew the quickest, easiest and most inexpensive way to fix that was to paint what didn’t work.

The wood trim got a fresh coat of white, and so did the dingy, dirty red brick.

The brass screen was sprayed painted a brushed silver, and the worn, unattractive red tile was primed and painted a charcoal gray.  {Don't mind the old Christmas decorations...we moved in on Christmas Eve.}

That solution worked for the short-term.  It helped to bring our fireplace into this decade, but then, you know me...I grew tired of the paint chipping up, and I started dreaming of how much better the fireplace could be.  In other words, I got antsy to cross another project off the list.  I decided it was time to try my hand at tiling.  Ahhhh!!

To get some inspiration for the project, I headed to The Tile Shop showroom, which luckily, just opened a few months ago near our house.  I thought I would make a bee-line for the marble tile choices, but I was mistaken.  The minute I stepped in their doors, I was drawn to all the beautiful displays they had set up.  My absolute favoriteeeee was this bathroom.  I loved every. single. thing. about. it.

After lots of unintentional browsing, I was able to remind myself that I was there for our hearth project, not for a bathroom re-do…so I made my way to the marble mosaic tiles.  I think it's safe to say that I am obsessed with marble tile.  The white and grey veining is perfect for our home, and I love that it’s a classic material.  If it's cut into square tiles, it can be traditional....subway tiles, it can be classic...and then there is the hex tile.  Ahhhhh, the hex tile.  Pardon me while I swoon. ;)

I love that in marble, the hex tile is a classic choice, with a modern twist...perfect for the look we wanted to achieve on our hearth!  {And I'm not gonna lie...some subway tile in a herringbone pattern would also be UH-mazing, but the thought of that was a little nerve-wracking for me to take on for my first tile job.  Eeeeek!!  Maybe that'll be the right choice for a backsplash when the time comes. ;)}

Thank you, Tile Shop for totally indulging my love of hex tiles.  I was able to drool all over them and narrow down my choice to the 1" and 2" mosaics, seen above. 

So with all of that inspiration in mind, it was time to get to business.  I was ready to show that old hearth who is boss!!

***Although I was super, duper lucky to get some free tile and materials for this project from The Tile Shop, this is not a sponsored post.  I've always promised to keep it real with you guys, so I wanted to let you guys know how much they rock! :)***

Debris Be Gone!!

Remember this deliciousness?  {Yes, I still swoon over my hubby…thankyouverymuch!}  Here is a quick recap where we were over Memorial Day weekend.

Well after all that destruction went down, the hubby and I had a lot of clean up to look forward to.  I’m not sure who was dreading it more…me, who knew I wouldn’t be able to handle major wheelbarrow loads, and therefore wouldn’t be as helpful/quick/handy as my better half, or hubby, who knew he’d be taking on the brunt of this heavy lifting.

Lucky for us, we have fan-freakin-tastic neighbors {yup, the ones whose house we painted}, and the hubby volunteered to help us clear away our debris.  {Picture the clouds parting and the sun shining through...hallelujah!} 

We started the process on Saturday morning.  The boys used our two wheelbarrows and loaded up the concrete piles we made last week on demo day.  They made trips back and forth to the dump site until everything was gone.  Clearly, I am not as strong as them so I concentrated my efforts where I would be most helpful.  I cleared the area of all the flagstone that made up the old patio.  The prettiest pieces, I carried to the other side of our house to continue a path we started a while ago.  The remaining bagillion pieces I stacked up in the corner of the yard so the boys could easily load and dispose of them after all the concrete was gone.  {Don’t worry, I kept a handful of slates in case we need them in the future.}

By the time all the flagstone was up, the boys were almost done with the concrete.  I NEVER, EVER, EVER would have thought clearing our disaster area {aka backyard} would only take us a handful of hours, but when you have two strong guys working together, things go MUCH more quickly! :)


Here is what the area looks like now...after my hubby weed-whacked all of our rogue plants growing in the area.

Now it’s time to impatiently wait for the rain to stop, so our concrete guy can get back on schedule and come give us the hardscaping of our dreams!!

Everybody's Working for the Weekend!

Yup, that's right...we {I use the term "we" quite loosely for this one} were busy working this past Memorial Day weekend.  Okay, okay maybe just the first half of Saturday, but still!  A whole heck of a lot got done before we overindulged in lots of food, movies and BBQs for the remainder of the weekend.

In a post or two, I may have mentioned that I despise our backyard, especially the ugly concrete slabs that had become my spray painting backdrops.  Unfortunately our backyard brings absolutely NOTHING to the table, and certainly doesn't make us want to go out and enjoy the great outdoors.

{Least favorite area of our yard.}

 {Close up view...basically where I spray paint everything. :) }

 {Small concrete pad at the top of the steps to our driveway.} 

And because of all the loveliness shown above, we previously called a stamped concrete guy to come and give us an estimate to do some work.  We wanted him to demo our old slabs and install a stamped concrete patio.  {We personally prefer stamped concrete to pavers, but I know many may disagree with us.}  His quote was quite reasonable for the work to be done {let's be clear...the patio we want is very sizable because if you're going to do it, do it once and do it right}, but holy moly...it was much higher than we were guess-timating!  Bummer!!!

He let us know that if we wanted to demo the slabs ourselves and clear away the concrete we could save $1,500.  At first, we didn't even consider this.  Jackhammers and flying concrete debris?!?!  It kind of freaked us out.  But after a couple weeks went by, and we investigated our slab {it seemed to be only about 3-4 inches thick}, we decided to look into demo'ing the slabs ourselves.

All it took was a couple minutes of reading some info on Home Depot's Tool Rental site, and I was sold.  We {meaning my big, strong hubby} could totally handle this!  So when Saturday rolled around, we headed straight to HD and rented an electric breaker...$75 for 4 hours.

Once we got home, we were both pretty anxious about how it would go.  Hubby suited up with long pants, work boots, safety glasses and ear protection....and off he went!

The breaker came with three different bits {I'm just calling them bits, because I don't know what they are really called}, and even though he used them all, hubby had a clear favorite he used for most of the project.  The breaker does all the work for you, but you have to constantly pick up this heavy piece of equipment and move it to the next area you want to break...and occasionally it'd get stuck in the rubble and you'd have to yank it out of the concrete.

Here is a little glimpse at the process...as well as some inadvertent eye candy for my female readers. ;)

{Getting the hang of it.}

{Switching out the "bit" to try a new one.}

{Making progress.}

{For those of you who follow me on Instagram [retroranchreno]...you saw this picture on Saturday.}

{The big slabs are almost done.}

{Trying to clear everything out from under the stairs.  There were two layers under there...one of concrete and one of brick.}

{No more little slab near the steps to the driveway!}

After almost two hours of hard work in crazy heat and humidity, hubby had everything broken up.  He was E-X-H-A-U-S-T-E-D!  No joke...I have never seen him beat like this, and we have taken on many long and exhausting days since purchasing this home.  I am really so thankful to have a husband who could take on this huge task.  I felt so bad that I couldn't help, so I just stood out in the porch and was his "support" while he tackled this major project.

And thanks to all of his hard work, we managed to return the breaker before our 4 hour deadline and even got money back from our initial deposit!  So, all in all, breaking up our old concrete cost us $66.

Of course, now comes the real fun!  We have to move allllll of the debris to a dump area we have near our house.  I am not looking forward to all of the wheelbarrowing we have in our future, but since it's saving us just over $1,400, I'll suck it up! :)

This all brings us one step closer to having an outdoor space we never thought we'd have!!  Woohooo!